Atenção

Fechar

Biblioteca

Artigos Técnicos

Artigo Científico | Ensaios de Tração e Torção | Inglês | 10/10/2006

Characteristics of the double-torsion test to determine the R-curve of ceramic materials

Autores: José de Anchieta Rodrigues, Maria da Consolação Fonseca de Albuquerque

Palavras-chave: double-torsion, fracture mechanics, r-curve

Resumo: Double-torsion tests were carried out on a commercial ceramic floor tile to verify whether this test is suitable for determining the R-curve of ceramics. The instantaneous crack length was obtained by means of compliance calibration, and it was found that the experimental compliance underestimates the real crack length. The load vs. displacement curves were also found to drop after maximum loading, causing the stress intensity factor to decline. The R-curves were calculated by two methods: linear elastic fracture mechanics and the energetic method. It was obtained that the average values of crack resistance, R, and the double of the work of fracture, 2 × gwof, did not depend on notch length, a0, which is a highly relevant finding, indicating that these parameters were less dependent on the test specimen's geometry. The proposal was to use small notches, which produce long stable crack propagation paths that in turn are particularly important in the case of coarse microstructures.

Clique aqui para ler na íntegra

Materials Research

« Voltar